What should I do if the air compressor is soaked in water when the typhoon "San Du" strikes?

Affected by Typhoon No. 14 this year, "Santo", the Central Meteorological Observatory issued a double warning of typhoon and heavy rain.

At 10 o'clock on the 12th, the Central Meteorological Observatory continued to issue a typhoon orange warning: It is expected that "Sandu" will land on the coast from Zhoushan to Sanmen, Zhejiang during the daytime on the 13th (38-45 m/s, 13-14, typhoon level or strong typhoon) Level), or pass the coastal waters of Zhoushan into Hangzhou Bay. From the 14th to the 15th, the sea surface or the area near the Hangzhou Bay whirled little. On the 16th, it began to move to the northeast, and the intensity gradually weakened.

At 10 o'clock on the 12th, the Central Meteorological Observatory issued a yellow warning of heavy rain: It is estimated that from 14:00 on the 12th to 14:00 on the 13th, northern and central eastern Zhejiang, Shanghai, southeast Jiangsu, southeast Anhui, Taiwan Island, southern Sichuan, southwest Chongqing, and Guizhou are expected There were heavy rains in parts of the northwest and other places. Some of the above-mentioned areas are accompanied by short-term heavy rainfall and local strong convective weather such as thunderstorms and gales.

        Before the typhoon hits, Janpa Compressor warmly reminds the air compressor to be windproof and rainproof:

1. Avoid rain and water leakage in the air compressor room. Be sure to close the doors and windows tightly to prevent rainwater from being blown to the air compressor, especially the electric control part and motor part of the air compressor;

2. Pay attention to the drainage problem around the air compressor room and ensure that the inside of the air compressor room is dry;

3. Pay attention to the safety of electricity use, strengthen the inspection and protection of the circuit, and do not start the machine immediately if there is water ingress;

4. Pay attention to the water content of the compressed air at the air end. The humidity of the air will increase in consecutive days of rain. If the post-processing effect of the air compressor is not good, the water content in the compressed air at the back end will increase, which will affect normal use.

If you find that the air compressor is soaking in water, you need to dry the motor and directly power it on. It will cause the air compressor to lock up, valve jamming, poor action of the lubricating oil, etc., and the necessary parts must be replaced, such as: If necessary, disassemble the air compressor for water pipe fittings and parts blocked by sediment to completely remove the water. For the sake of insurance, Deman after-sales recommends that users should immediately notify the air compressor service provider for inspection and repair, and do not disassemble the machine without authorization, so as to avoid greater equipment damage and economic losses!